Emulated Output to PA

Discussion - Artist Series amplifiers. The New Classic.
Post Reply
doctordin
Posts: 1
Joined: Sun Oct 01, 2017 5:25 am

Sun Oct 01, 2017 5:31 am

I'm having trouble getting a good sound plugging into a PA. I hoped it would be as simple as running a cable from the emulated output to the mixing desk and a little eq tweaking. What I found was that I was getting very low signal and really had to crank the levels on the mixing desk. The sound was quite trebly, not at all like the amp. I tried rerouting through a DI box, which helped a bit, but still not a great sound. Wondering what other people are doing please.

User avatar
flimbo
Posts: 240
Joined: Sun Apr 13, 2014 2:53 pm

Sun Oct 01, 2017 9:12 am

What amp?

User avatar
thephantum
Posts: 1273
Joined: Wed Jan 29, 2014 6:42 pm
Location: Virginia, United States

Sun Oct 01, 2017 9:05 pm

I usually mic the speaker and use PA to match levels. That's the best way to get the sound you hear from the amp...especially if your tone relies on power tube compression and/or OD . I also run an attenuator. So, if the amp is too loud for the venue, then I can knock down the dB level to match.
WARNING: Tube amps contain LETHAL voltages, even long after they have been unplugged. If you are not familiar with how to safety work on high voltage circuits, then PLEASE don't die...take it to a tech.

Rugbygirlsdad
Posts: 4
Joined: Wed Jan 06, 2016 10:37 am
Location: Dorset

Tue Oct 24, 2017 10:27 am

I have another question regarding the emulated out (DI out).
Do the volume controls on the amp have any impact on the strength of the signal going to the desk or am I at the mercy of the sound guy?

Yoav Orion
Posts: 3
Joined: Wed May 30, 2018 12:11 pm
Location: Israel

Wed May 30, 2018 1:42 pm

Use a screened lead! the trebely sound may be due to hi frequency noises...

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 0 guests