I've just bought a cub 40 mk ii and I am very pleased with it. I've also just got hold of a helix Lt which is able to do channel switching.
I've had s bit of success where the amp channel does change but not necessarily as expected.
The instructions below talk about pressing the "clean select"??? I've taken this to mean the channel select . And two LEDs will flash. When I do this only one led flashes.
I've tried to do the settings as per the chart in the manual but it doesn't work as documented.
Has anyone had any success with this yet?
"EXTERNAL SWITCHING MODE: This mode is intended for people who wish to
control the same main features of the amp using an external switching device that
connects via the TRS connection of the socket.
To switch to External Switching Mode: simply press and hold the Clean Select
and Clean Voice switches for 5 seconds. The green LEDs will then flash together
to indicate the change of mode. The amplifier will retain this mode, even when
switched off, until it is changed back to normal/footswitch mode"