series one 100 and cab help

General Discussion Forum - Voice The Sound In Your Head
Post Reply
Posts: 2
Joined: Tue Feb 19, 2013 8:00 pm

Sat Mar 09, 2013 1:33 pm

Hi everyone,
This may seem like a stupid question :-( I have a series one 100 head and have just bought a ht212 cab to go with it (was using a marshall 2 x 12 before) question is this: if i take 2 leads from the back of the amp into the two inputs into the cab what should I set the amps impedence selector to ?
Many Thanks in anticipation

Posts: 8
Joined: Tue Mar 26, 2013 1:38 pm

Wed Mar 27, 2013 10:02 am


If You using 2 speaker patches and HT212 is 8Ohm mono - 160W and 16 Ohm stereo - 2x80W then setup impedance to 16/4 Ohm on amp. If cab is second hand, worth to check speakers impedance as well.

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 11 guests